Polarized mating geometry: Ensures header and receptacle cannot be mismated.

The epoxy also should be the insulator for the back of the connector. Self aligning interface: Enables operator to mate connectors in hard to reach areas. Re-Mount the wires with metal terminals (presumably female) into the cut-down 3/8' plastic block, right angle the the wires at the back (ensuring terminal ends are flush to the molex insert end), then epoxy the back end of the cut down connector using JB Weld so that metal terminals in the modified block are epoxy fused in it.Īpply the epoxy suitably to ensure that the terminals cannot move (eg, laterally or fore & aft) so that they will neither short by touching together nor pop out when the molex is removed/inserted. In this case lets say that the remaining piece turns out to be a plastic block with four connector holes thats 3/8 '. Terminal Sizes: IP Rating: Circuits: Voltage (MAX): 0.50mm, 1.00mm, 2.80mm. A Molex connector is a two-piece pin-and-socket interconnection which became an early electronic standard. Remove the pins from the plastic body, then using a fine blade hacksaw, slice the back end of the body of the plastic molex connector to a length that will fit. Compactus Sealed Hybrid Connectors are robust, high-density, automotive-grade connectors that permit manufacturers to fit more power and signal transmission ability into a small space. AMP Mate-n-Lok and Molex standard 0.093-inch pin and socket power connectors Molex standard 0.093-inch pin and socket connectors Molex disk drive power connection system tool and connectors ATX connector.

Take a regular molex connector (presumably female). This helps to meet the needs of makers in various. What Im gonna say may be a bit off the wall, but here goes. Both versions of the Mizu-P25 family provide some of the smallest mated diameters of any similar system.

Super small tiny molex connectors